ath9k_hw: fix PA predistortion miscalibration

If any bins from the training data are skipped (i != max_index), the
calculated compensation curve gets distorted, and the signal will be
wildly overamplified. This may be the cause of the reported hardware
damage that was caused by PA predistortion (because of which PAPRD was
disabled by default).

When calculating the x_est, Y, theta values, the use of max_index and i
was reversed. i points to the bin index whereas max_index refers to the
index of the calculated arrays.

Note that PA predistortion is still disabled, it will be re-enabled
after it has been properly validated.
Signed-off-by: NFelix Fietkau <nbd@openwrt.org>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

drivers/net/wireless/ath/ath9k/ar9003_paprd.c

@@ -454,6 +454,8 @@ static bool create_pa_curve(u32 *data_L, u32 *data_U, u32 *pa_table, u16 *gain)
 		if (accum_cnt <= thresh_accum_cnt)
 			continue;
 
+		max_index++;
+
 		/* sum(tx amplitude) */
 		accum_tx = ((data_L[i] >> 16) & 0xffff) |
 		    ((data_U[i] & 0x7ff) << 16);
@@ -468,20 +470,21 @@ static bool create_pa_curve(u32 *data_L, u32 *data_U, u32 *pa_table, u16 *gain)
 
 		accum_tx <<= scale_factor;
 		accum_rx <<= scale_factor;
-		x_est[i + 1] = (((accum_tx + accum_cnt) / accum_cnt) + 32) >>
+		x_est[max_index] =
+			(((accum_tx + accum_cnt) / accum_cnt) + 32) >>
 			scale_factor;
 
-		Y[i + 1] = ((((accum_rx + accum_cnt) / accum_cnt) + 32) >>
+		Y[max_index] =
+			((((accum_rx + accum_cnt) / accum_cnt) + 32) >>
 			    scale_factor) +
-			    (1 << scale_factor) * max_index + 16;
+			(1 << scale_factor) * i + 16;
 
 		if (accum_ang >= (1 << 26))
 			accum_ang -= 1 << 27;
 
-		theta[i + 1] = ((accum_ang * (1 << scale_factor)) + accum_cnt) /
+		theta[max_index] =
+			((accum_ang * (1 << scale_factor)) + accum_cnt) /
 			accum_cnt;
-
-		max_index++;
 	}
 
 	/*