diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h index 72741f431001237c8549d81801be7bbb8a465023..b02356fded8ed5db135582efc17483d296fb9958 100644 --- a/drivers/gpu/drm/i915/i915_reg.h +++ b/drivers/gpu/drm/i915/i915_reg.h @@ -2144,7 +2144,7 @@ enum skl_disp_power_wells { # define GPIO_DATA_VAL_IN (1 << 12) # define GPIO_DATA_PULLUP_DISABLE (1 << 13) -#define GMBUS0 0x5100 /* clock/port select */ +#define GMBUS0 (dev_priv->gpio_mmio_base + 0x5100) /* clock/port select */ #define GMBUS_RATE_100KHZ (0<<8) #define GMBUS_RATE_50KHZ (1<<8) #define GMBUS_RATE_400KHZ (2<<8) /* reserved on Pineview */ @@ -2163,7 +2163,7 @@ enum skl_disp_power_wells { #define GMBUS_PIN_2_BXT 2 #define GMBUS_PIN_3_BXT 3 #define GMBUS_NUM_PINS 7 /* including 0 */ -#define GMBUS1 0x5104 /* command/status */ +#define GMBUS1 (dev_priv->gpio_mmio_base + 0x5104) /* command/status */ #define GMBUS_SW_CLR_INT (1<<31) #define GMBUS_SW_RDY (1<<30) #define GMBUS_ENT (1<<29) /* enable timeout */ @@ -2177,7 +2177,7 @@ enum skl_disp_power_wells { #define GMBUS_SLAVE_ADDR_SHIFT 1 #define GMBUS_SLAVE_READ (1<<0) #define GMBUS_SLAVE_WRITE (0<<0) -#define GMBUS2 0x5108 /* status */ +#define GMBUS2 (dev_priv->gpio_mmio_base + 0x5108) /* status */ #define GMBUS_INUSE (1<<15) #define GMBUS_HW_WAIT_PHASE (1<<14) #define GMBUS_STALL_TIMEOUT (1<<13) @@ -2185,14 +2185,14 @@ enum skl_disp_power_wells { #define GMBUS_HW_RDY (1<<11) #define GMBUS_SATOER (1<<10) #define GMBUS_ACTIVE (1<<9) -#define GMBUS3 0x510c /* data buffer bytes 3-0 */ -#define GMBUS4 0x5110 /* interrupt mask (Pineview+) */ +#define GMBUS3 (dev_priv->gpio_mmio_base + 0x510c) /* data buffer bytes 3-0 */ +#define GMBUS4 (dev_priv->gpio_mmio_base + 0x5110) /* interrupt mask (Pineview+) */ #define GMBUS_SLAVE_TIMEOUT_EN (1<<4) #define GMBUS_NAK_EN (1<<3) #define GMBUS_IDLE_EN (1<<2) #define GMBUS_HW_WAIT_EN (1<<1) #define GMBUS_HW_RDY_EN (1<<0) -#define GMBUS5 0x5120 /* byte index */ +#define GMBUS5 (dev_priv->gpio_mmio_base + 0x5120) /* byte index */ #define GMBUS_2BYTE_INDEX_EN (1<<31) /* diff --git a/drivers/gpu/drm/i915/intel_i2c.c b/drivers/gpu/drm/i915/intel_i2c.c index a64f26c670afed95ff45fb8b26ef1c1c0ae0d145..1369fc41d03913f217894c700fa220465362b975 100644 --- a/drivers/gpu/drm/i915/intel_i2c.c +++ b/drivers/gpu/drm/i915/intel_i2c.c @@ -114,8 +114,8 @@ intel_i2c_reset(struct drm_device *dev) { struct drm_i915_private *dev_priv = dev->dev_private; - I915_WRITE(dev_priv->gpio_mmio_base + GMBUS0, 0); - I915_WRITE(dev_priv->gpio_mmio_base + GMBUS4, 0); + I915_WRITE(GMBUS0, 0); + I915_WRITE(GMBUS4, 0); } static void intel_i2c_quirk_set(struct drm_i915_private *dev_priv, bool enable) @@ -261,7 +261,6 @@ gmbus_wait_hw_status(struct drm_i915_private *dev_priv, u32 gmbus4_irq_en) { int i; - int reg_offset = dev_priv->gpio_mmio_base; u32 gmbus2 = 0; DEFINE_WAIT(wait); @@ -271,13 +270,13 @@ gmbus_wait_hw_status(struct drm_i915_private *dev_priv, /* Important: The hw handles only the first bit, so set only one! Since * we also need to check for NAKs besides the hw ready/idle signal, we * need to wake up periodically and check that ourselves. */ - I915_WRITE(GMBUS4 + reg_offset, gmbus4_irq_en); + I915_WRITE(GMBUS4, gmbus4_irq_en); for (i = 0; i < msecs_to_jiffies_timeout(50); i++) { prepare_to_wait(&dev_priv->gmbus_wait_queue, &wait, TASK_UNINTERRUPTIBLE); - gmbus2 = I915_READ_NOTRACE(GMBUS2 + reg_offset); + gmbus2 = I915_READ_NOTRACE(GMBUS2); if (gmbus2 & (GMBUS_SATOER | gmbus2_status)) break; @@ -285,7 +284,7 @@ gmbus_wait_hw_status(struct drm_i915_private *dev_priv, } finish_wait(&dev_priv->gmbus_wait_queue, &wait); - I915_WRITE(GMBUS4 + reg_offset, 0); + I915_WRITE(GMBUS4, 0); if (gmbus2 & GMBUS_SATOER) return -ENXIO; @@ -298,20 +297,19 @@ static int gmbus_wait_idle(struct drm_i915_private *dev_priv) { int ret; - int reg_offset = dev_priv->gpio_mmio_base; -#define C ((I915_READ_NOTRACE(GMBUS2 + reg_offset) & GMBUS_ACTIVE) == 0) +#define C ((I915_READ_NOTRACE(GMBUS2) & GMBUS_ACTIVE) == 0) if (!HAS_GMBUS_IRQ(dev_priv->dev)) return wait_for(C, 10); /* Important: The hw handles only the first bit, so set only one! */ - I915_WRITE(GMBUS4 + reg_offset, GMBUS_IDLE_EN); + I915_WRITE(GMBUS4, GMBUS_IDLE_EN); ret = wait_event_timeout(dev_priv->gmbus_wait_queue, C, msecs_to_jiffies_timeout(10)); - I915_WRITE(GMBUS4 + reg_offset, 0); + I915_WRITE(GMBUS4, 0); if (ret) return 0; @@ -325,9 +323,7 @@ gmbus_xfer_read_chunk(struct drm_i915_private *dev_priv, unsigned short addr, u8 *buf, unsigned int len, u32 gmbus1_index) { - int reg_offset = dev_priv->gpio_mmio_base; - - I915_WRITE(GMBUS1 + reg_offset, + I915_WRITE(GMBUS1, gmbus1_index | GMBUS_CYCLE_WAIT | (len << GMBUS_BYTE_COUNT_SHIFT) | @@ -342,7 +338,7 @@ gmbus_xfer_read_chunk(struct drm_i915_private *dev_priv, if (ret) return ret; - val = I915_READ(GMBUS3 + reg_offset); + val = I915_READ(GMBUS3); do { *buf++ = val & 0xff; val >>= 8; @@ -380,7 +376,6 @@ static int gmbus_xfer_write_chunk(struct drm_i915_private *dev_priv, unsigned short addr, u8 *buf, unsigned int len) { - int reg_offset = dev_priv->gpio_mmio_base; unsigned int chunk_size = len; u32 val, loop; @@ -390,8 +385,8 @@ gmbus_xfer_write_chunk(struct drm_i915_private *dev_priv, len -= 1; } - I915_WRITE(GMBUS3 + reg_offset, val); - I915_WRITE(GMBUS1 + reg_offset, + I915_WRITE(GMBUS3, val); + I915_WRITE(GMBUS1, GMBUS_CYCLE_WAIT | (chunk_size << GMBUS_BYTE_COUNT_SHIFT) | (addr << GMBUS_SLAVE_ADDR_SHIFT) | @@ -404,7 +399,7 @@ gmbus_xfer_write_chunk(struct drm_i915_private *dev_priv, val |= *buf++ << (8 * loop); } while (--len && ++loop < 4); - I915_WRITE(GMBUS3 + reg_offset, val); + I915_WRITE(GMBUS3, val); ret = gmbus_wait_hw_status(dev_priv, GMBUS_HW_RDY, GMBUS_HW_RDY_EN); @@ -452,7 +447,6 @@ gmbus_is_index_read(struct i2c_msg *msgs, int i, int num) static int gmbus_xfer_index_read(struct drm_i915_private *dev_priv, struct i2c_msg *msgs) { - int reg_offset = dev_priv->gpio_mmio_base; u32 gmbus1_index = 0; u32 gmbus5 = 0; int ret; @@ -466,13 +460,13 @@ gmbus_xfer_index_read(struct drm_i915_private *dev_priv, struct i2c_msg *msgs) /* GMBUS5 holds 16-bit index */ if (gmbus5) - I915_WRITE(GMBUS5 + reg_offset, gmbus5); + I915_WRITE(GMBUS5, gmbus5); ret = gmbus_xfer_read(dev_priv, &msgs[1], gmbus1_index); /* Clear GMBUS5 after each index transfer */ if (gmbus5) - I915_WRITE(GMBUS5 + reg_offset, 0); + I915_WRITE(GMBUS5, 0); return ret; } @@ -486,7 +480,7 @@ gmbus_xfer(struct i2c_adapter *adapter, struct intel_gmbus, adapter); struct drm_i915_private *dev_priv = bus->dev_priv; - int i = 0, inc, try = 0, reg_offset; + int i = 0, inc, try = 0; int ret = 0; intel_aux_display_runtime_get(dev_priv); @@ -497,10 +491,8 @@ gmbus_xfer(struct i2c_adapter *adapter, goto out; } - reg_offset = dev_priv->gpio_mmio_base; - retry: - I915_WRITE(GMBUS0 + reg_offset, bus->reg0); + I915_WRITE(GMBUS0, bus->reg0); for (; i < num; i += inc) { inc = 1; @@ -530,7 +522,7 @@ gmbus_xfer(struct i2c_adapter *adapter, * a STOP on the very first cycle. To simplify the code we * unconditionally generate the STOP condition with an additional gmbus * cycle. */ - I915_WRITE(GMBUS1 + reg_offset, GMBUS_CYCLE_STOP | GMBUS_SW_RDY); + I915_WRITE(GMBUS1, GMBUS_CYCLE_STOP | GMBUS_SW_RDY); /* Mark the GMBUS interface as disabled after waiting for idle. * We will re-enable it at the start of the next xfer, @@ -541,7 +533,7 @@ gmbus_xfer(struct i2c_adapter *adapter, adapter->name); ret = -ETIMEDOUT; } - I915_WRITE(GMBUS0 + reg_offset, 0); + I915_WRITE(GMBUS0, 0); ret = ret ?: i; goto out; @@ -570,9 +562,9 @@ gmbus_xfer(struct i2c_adapter *adapter, * of resetting the GMBUS controller and so clearing the * BUS_ERROR raised by the slave's NAK. */ - I915_WRITE(GMBUS1 + reg_offset, GMBUS_SW_CLR_INT); - I915_WRITE(GMBUS1 + reg_offset, 0); - I915_WRITE(GMBUS0 + reg_offset, 0); + I915_WRITE(GMBUS1, GMBUS_SW_CLR_INT); + I915_WRITE(GMBUS1, 0); + I915_WRITE(GMBUS0, 0); DRM_DEBUG_KMS("GMBUS [%s] NAK for addr: %04x %c(%d)\n", adapter->name, msgs[i].addr, @@ -595,7 +587,7 @@ gmbus_xfer(struct i2c_adapter *adapter, timeout: DRM_INFO("GMBUS [%s] timed out, falling back to bit banging on pin %d\n", bus->adapter.name, bus->reg0 & 0xff); - I915_WRITE(GMBUS0 + reg_offset, 0); + I915_WRITE(GMBUS0, 0); /* Hardware may not support GMBUS over these pins? Try GPIO bitbanging instead. */ bus->force_bit = 1;