Merge branch 'heads/soc2' into boards2-base

Conflicts:
	arch/arm/mach-shmobile/board-lager.c

Documentation/devicetree/bindings/mmc/tmio_mmc.txt

@@ -9,12 +9,15 @@ compulsory and any optional properties, common to all SD/MMC drivers, as
 described in mmc.txt, can be used. Additionally the following tmio_mmc-specific
 optional bindings can be used.
 
+Required properties:
+- compatible:	"renesas,sdhi-shmobile" - a generic sh-mobile SDHI unit
+		"renesas,sdhi-sh7372" - SDHI IP on SH7372 SoC
+		"renesas,sdhi-sh73a0" - SDHI IP on SH73A0 SoC
+		"renesas,sdhi-r8a73a4" - SDHI IP on R8A73A4 SoC
+		"renesas,sdhi-r8a7740" - SDHI IP on R8A7740 SoC
+		"renesas,sdhi-r8a7778" - SDHI IP on R8A7778 SoC
+		"renesas,sdhi-r8a7779" - SDHI IP on R8A7779 SoC
+		"renesas,sdhi-r8a7790" - SDHI IP on R8A7790 SoC
+
 Optional properties:
 - toshiba,mmc-wrprotect-disable: write-protect detection is unavailable
-
-When used with Renesas SDHI hardware, the following compatibility strings
-configure various model-specific properties:
-
-"renesas,sh7372-sdhi":	(default) compatible with SH7372
-"renesas,r8a7740-sdhi":	compatible with R8A7740: certain MMC/SD commands have to
-			wait for the interface to become idle.

arch/arm/boot/dts/r8a73a4.dtsi

@@ -193,7 +193,7 @@
 	};
 
 	sdhi0: sdhi@ee100000 {
-		compatible = "renesas,r8a73a4-sdhi";
+		compatible = "renesas,sdhi-r8a73a4";
 		reg = <0 0xee100000 0 0x100>;
 		interrupt-parent = <&gic>;
 		interrupts = <0 165 4>;
@@ -202,7 +202,7 @@
 	};
 
 	sdhi1: sdhi@ee120000 {
-		compatible = "renesas,r8a73a4-sdhi";
+		compatible = "renesas,sdhi-r8a73a4";
 		reg = <0 0xee120000 0 0x100>;
 		interrupt-parent = <&gic>;
 		interrupts = <0 166 4>;
@@ -211,7 +211,7 @@
 	};
 
 	sdhi2: sdhi@ee140000 {
-		compatible = "renesas,r8a73a4-sdhi";
+		compatible = "renesas,sdhi-r8a73a4";
 		reg = <0 0xee140000 0 0x100>;
 		interrupt-parent = <&gic>;
 		interrupts = <0 167 4>;

arch/arm/boot/dts/r8a7778.dtsi

@@ -96,6 +96,5 @@
 	pfc: pfc@fffc0000 {
 		compatible = "renesas,pfc-r8a7778";
 		reg = <0xfffc000 0x118>;
-		#gpio-range-cells = <3>;
 	};
 };

arch/arm/boot/dts/r8a7779.dtsi

@@ -188,7 +188,6 @@
 	pfc: pfc@fffc0000 {
 		compatible = "renesas,pfc-r8a7779";
 		reg = <0xfffc0000 0x23c>;
-		#gpio-range-cells = <3>;
 	};
 
 	thermal@ffc48000 {

arch/arm/boot/dts/r8a7790.dtsi

@@ -148,11 +148,10 @@
 	pfc: pfc@e6060000 {
 		compatible = "renesas,pfc-r8a7790";
 		reg = <0 0xe6060000 0 0x250>;
-		#gpio-range-cells = <3>;
 	};
 
 	sdhi0: sdhi@ee100000 {
-		compatible = "renesas,r8a7790-sdhi";
+		compatible = "renesas,sdhi-r8a7790";
 		reg = <0 0xee100000 0 0x100>;
 		interrupt-parent = <&gic>;
 		interrupts = <0 165 4>;
@@ -161,7 +160,7 @@
 	};
 
 	sdhi1: sdhi@ee120000 {
-		compatible = "renesas,r8a7790-sdhi";
+		compatible = "renesas,sdhi-r8a7790";
 		reg = <0 0xee120000 0 0x100>;
 		interrupt-parent = <&gic>;
 		interrupts = <0 166 4>;
@@ -170,7 +169,7 @@
 	};
 
 	sdhi2: sdhi@ee140000 {
-		compatible = "renesas,r8a7790-sdhi";
+		compatible = "renesas,sdhi-r8a7790";
 		reg = <0 0xee140000 0 0x100>;
 		interrupt-parent = <&gic>;
 		interrupts = <0 167 4>;
@@ -179,7 +178,7 @@
 	};
 
 	sdhi3: sdhi@ee160000 {
-		compatible = "renesas,r8a7790-sdhi";
+		compatible = "renesas,sdhi-r8a7790";
 		reg = <0 0xee160000 0 0x100>;
 		interrupt-parent = <&gic>;
 		interrupts = <0 168 4>;

arch/arm/boot/dts/sh73a0.dtsi

@@ -196,7 +196,7 @@
 	};
 
 	sdhi0: sdhi@ee100000 {
-		compatible = "renesas,r8a7740-sdhi";
+		compatible = "renesas,sdhi-r8a7740";
 		reg = <0xee100000 0x100>;
 		interrupt-parent = <&gic>;
 		interrupts = <0 83 4
@@ -208,7 +208,7 @@
 
 	/* SDHI1 and SDHI2 have no CD pins, no need for CD IRQ */
 	sdhi1: sdhi@ee120000 {
-		compatible = "renesas,r8a7740-sdhi";
+		compatible = "renesas,sdhi-r8a7740";
 		reg = <0xee120000 0x100>;
 		interrupt-parent = <&gic>;
 		interrupts = <0 88 4
@@ -219,7 +219,7 @@
 	};
 
 	sdhi2: sdhi@ee140000 {
-		compatible = "renesas,r8a7740-sdhi";
+		compatible = "renesas,sdhi-r8a7740";
 		reg = <0xee140000 0x100>;
 		interrupt-parent = <&gic>;
 		interrupts = <0 104 4

arch/arm/mach-shmobile/board-armadillo800eva.c

@@ -1109,9 +1109,9 @@ static const struct pinctrl_map eva_pinctrl_map[] = {
 	PIN_MAP_MUX_GROUP_DEFAULT("asoc-simple-card.1", "pfc-r8a7740",
 				  "fsib_mclk_in", "fsib"),
 	/* GETHER */
-	PIN_MAP_MUX_GROUP_DEFAULT("sh-eth", "pfc-r8a7740",
+	PIN_MAP_MUX_GROUP_DEFAULT("r8a7740-gether", "pfc-r8a7740",
 				  "gether_mii", "gether"),
-	PIN_MAP_MUX_GROUP_DEFAULT("sh-eth", "pfc-r8a7740",
+	PIN_MAP_MUX_GROUP_DEFAULT("r8a7740-gether", "pfc-r8a7740",
 				  "gether_int", "gether"),
 	/* HDMI */
 	PIN_MAP_MUX_GROUP_DEFAULT("sh-mobile-hdmi", "pfc-r8a7740",

arch/arm/mach-shmobile/board-lager.c

@@ -30,6 +30,7 @@
 #include <linux/platform_data/gpio-rcar.h>
 #include <linux/platform_data/rcar-du.h>
 #include <linux/platform_device.h>
+#include <linux/phy.h>
 #include <linux/regulator/fixed.h>
 #include <linux/regulator/machine.h>
 #include <linux/sh_eth.h>
@@ -223,6 +224,30 @@ static void __init lager_add_standard_devices(void)
 	lager_add_du_device();
 }
 
+/*
+ * Ether LEDs on the Lager board are named LINK and ACTIVE which corresponds
+ * to non-default 01 setting of the Micrel KSZ8041 PHY control register 1 bits
+ * 14-15. We have to set them back to 01 from the default 00 value each time
+ * the PHY is reset. It's also important because the PHY's LED0 signal is
+ * connected to SoC's ETH_LINK signal and in the PHY's default mode it will
+ * bounce on and off after each packet, which we apparently want to avoid.
+ */
+static int lager_ksz8041_fixup(struct phy_device *phydev)
+{
+	u16 phyctrl1 = phy_read(phydev, 0x1e);
+
+	phyctrl1 &= ~0xc000;
+	phyctrl1 |= 0x4000;
+	return phy_write(phydev, 0x1e, phyctrl1);
+}
+
+static void __init lager_init(void)
+{
+	lager_add_standard_devices();
+
+	phy_register_fixup_for_id("r8a7790-ether-ff:01", lager_ksz8041_fixup);
+}
+
 static const char *lager_boards_compat_dt[] __initdata = {
 	"renesas,lager",
 	NULL,
@@ -232,6 +257,6 @@ DT_MACHINE_START(LAGER_DT, "lager")
 	.smp		= smp_ops(r8a7790_smp_ops),
 	.init_early	= r8a7790_init_early,
 	.init_time	= rcar_gen2_timer_init,
-	.init_machine	= lager_add_standard_devices,
+	.init_machine	= lager_init,
 	.dt_compat	= lager_boards_compat_dt,
 MACHINE_END

drivers/gpio/gpio-rcar.c

@@ -293,10 +293,9 @@ static void gpio_rcar_parse_pdata(struct gpio_rcar_priv *p)
 	if (pdata) {
 		p->config = *pdata;
 	} else if (IS_ENABLED(CONFIG_OF) && np) {
-		ret = of_parse_phandle_with_args(np, "gpio-ranges",
-				"#gpio-range-cells", 0, &args);
-		p->config.number_of_pins = ret == 0 && args.args_count == 3
-					 ? args.args[2]
+		ret = of_parse_phandle_with_fixed_args(np, "gpio-ranges", 3, 0,
+						       &args);
+		p->config.number_of_pins = ret == 0 ? args.args[2]
 					 : RCAR_MAX_GPIO_PER_BANK;
 		p->config.gpio_base = -1;
 	}

drivers/mmc/host/sh_mobile_sdhi.c

@@ -113,14 +113,14 @@ static const struct sh_mobile_sdhi_ops sdhi_ops = {
 };
 
 static const struct of_device_id sh_mobile_sdhi_of_match[] = {
-	{ .compatible = "renesas,shmobile-sdhi" },
-	{ .compatible = "renesas,sh7372-sdhi" },
-	{ .compatible = "renesas,sh73a0-sdhi", .data = &sh_mobile_sdhi_of_cfg[0], },
-	{ .compatible = "renesas,r8a73a4-sdhi", .data = &sh_mobile_sdhi_of_cfg[0], },
-	{ .compatible = "renesas,r8a7740-sdhi", .data = &sh_mobile_sdhi_of_cfg[0], },
-	{ .compatible = "renesas,r8a7778-sdhi", .data = &sh_mobile_sdhi_of_cfg[0], },
-	{ .compatible = "renesas,r8a7779-sdhi", .data = &sh_mobile_sdhi_of_cfg[0], },
-	{ .compatible = "renesas,r8a7790-sdhi", .data = &sh_mobile_sdhi_of_cfg[0], },
+	{ .compatible = "renesas,sdhi-shmobile" },
+	{ .compatible = "renesas,sdhi-sh7372" },
+	{ .compatible = "renesas,sdhi-sh73a0", .data = &sh_mobile_sdhi_of_cfg[0], },
+	{ .compatible = "renesas,sdhi-r8a73a4", .data = &sh_mobile_sdhi_of_cfg[0], },
+	{ .compatible = "renesas,sdhi-r8a7740", .data = &sh_mobile_sdhi_of_cfg[0], },
+	{ .compatible = "renesas,sdhi-r8a7778", .data = &sh_mobile_sdhi_of_cfg[0], },
+	{ .compatible = "renesas,sdhi-r8a7779", .data = &sh_mobile_sdhi_of_cfg[0], },
+	{ .compatible = "renesas,sdhi-r8a7790", .data = &sh_mobile_sdhi_of_cfg[0], },
 	{},
 };
 MODULE_DEVICE_TABLE(of, sh_mobile_sdhi_of_match);