ath10k: skip data calibration for non-bmi target

In non-bmi target ex. WCN3990, data calibration
is handled via QMI.

Skip data calibration in debug routine to enable ath10k
debugfs for non bmi targets.
Signed-off-by: NSurabhi Vishnoi <svishnoi@codeaurora.org>
Signed-off-by: NKalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/ath/ath10k/debug.c

@@ -1727,7 +1727,9 @@ int ath10k_debug_start(struct ath10k *ar)
 			ath10k_warn(ar, "failed to disable pktlog: %d\n", ret);
 	}
 
-	if (ar->debug.nf_cal_period) {
+	if (ar->debug.nf_cal_period &&
+	    !test_bit(ATH10K_FW_FEATURE_NON_BMI,
+		      ar->normal_mode_fw.fw_file.fw_features)) {
 		ret = ath10k_wmi_pdev_set_param(ar,
 						ar->wmi.pdev_param->cal_period,
 						ar->debug.nf_cal_period);
@@ -1744,6 +1746,8 @@ void ath10k_debug_stop(struct ath10k *ar)
 {
 	lockdep_assert_held(&ar->conf_mutex);
 
+	if (!test_bit(ATH10K_FW_FEATURE_NON_BMI,
+		      ar->normal_mode_fw.fw_file.fw_features))
 		ath10k_debug_cal_data_fetch(ar);
 
 	/* Must not use _sync to avoid deadlock, we do that in
@@ -2367,14 +2371,17 @@ int ath10k_debug_register(struct ath10k *ar)
 	debugfs_create_file("fw_dbglog", 0600, ar->debug.debugfs_phy, ar,
 			    &fops_fw_dbglog);
 
+	if (!test_bit(ATH10K_FW_FEATURE_NON_BMI,
+		      ar->normal_mode_fw.fw_file.fw_features)) {
 		debugfs_create_file("cal_data", 0400, ar->debug.debugfs_phy, ar,
 				    &fops_cal_data);
 
-	debugfs_create_file("ani_enable", 0600, ar->debug.debugfs_phy, ar,
-			    &fops_ani_enable);
-
 		debugfs_create_file("nf_cal_period", 0600, ar->debug.debugfs_phy, ar,
 				    &fops_nf_cal_period);
+	}
+
+	debugfs_create_file("ani_enable", 0600, ar->debug.debugfs_phy, ar,
+			    &fops_ani_enable);
 
 	if (IS_ENABLED(CONFIG_ATH10K_DFS_CERTIFIED)) {
 		debugfs_create_file("dfs_simulate_radar", 0200, ar->debug.debugfs_phy,