net: mvpp2: fix the phylink mode validation

[ Upstream commit 1b451fb2051b464b9758c09a3492104403252e2b ]

The mvpp2_phylink_validate() sets all modes that are supported by a
given PPv2 port. An mistake made the 10000baseT_Full mode being
advertised in some cases when a port wasn't configured to perform at
10G. This patch fixes this.

Fixes: d97c9f4a ("net: mvpp2: 1000baseX support")
Reported-by: NRussell King <linux@armlinux.org.uk>
Signed-off-by: NAntoine Tenart <antoine.tenart@bootlin.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c

@@ -4293,6 +4293,7 @@ static void mvpp2_phylink_validate(struct net_device *dev,
 	case PHY_INTERFACE_MODE_XAUI:
 	case PHY_INTERFACE_MODE_NA:
 		if (port->gop_id == 0) {
+			phylink_set(mask, 10000baseT_Full);
 			phylink_set(mask, 10000baseCR_Full);
 			phylink_set(mask, 10000baseSR_Full);
 			phylink_set(mask, 10000baseLR_Full);
@@ -4310,7 +4311,6 @@ static void mvpp2_phylink_validate(struct net_device *dev,
 		phylink_set(mask, 10baseT_Full);
 		phylink_set(mask, 100baseT_Half);
 		phylink_set(mask, 100baseT_Full);
-		phylink_set(mask, 10000baseT_Full);
 		/* Fall-through */
 	case PHY_INTERFACE_MODE_1000BASEX:
 	case PHY_INTERFACE_MODE_2500BASEX: