提交 4deb7c1e 编写于 作者: J Jeff Garzik 提交者: Dominik Brodowski

[PATCH] PCMCIA: handle sysfs, PCI errors

Handle sysfs and PCI errors correctly.
Signed-off-by: NJeff Garzik <jeff@garzik.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NDominik Brodowski <linux@dominikbrodowski.net>
上级 26aaa3c2
......@@ -128,9 +128,12 @@ static int proc_read_drivers(char *buf, char **start, off_t pos,
int count, int *eof, void *data)
{
char *p = buf;
int rc;
bus_for_each_drv(&pcmcia_bus_type, NULL,
rc = bus_for_each_drv(&pcmcia_bus_type, NULL,
(void *) &p, proc_read_drivers_callback);
if (rc < 0)
return rc;
return (p - buf);
}
......@@ -269,8 +272,10 @@ static int bind_request(struct pcmcia_socket *s, bind_info_t *bind_info)
* Prevent this racing with a card insertion.
*/
mutex_lock(&s->skt_mutex);
bus_rescan_devices(&pcmcia_bus_type);
ret = bus_rescan_devices(&pcmcia_bus_type);
mutex_unlock(&s->skt_mutex);
if (ret)
goto err_put_module;
/* check whether the driver indeed matched. I don't care if this
* is racy or not, because it can only happen on cardmgr access
......
......@@ -1197,8 +1197,12 @@ static int __devinit yenta_probe (struct pci_dev *dev, const struct pci_device_i
ret = pcmcia_register_socket(&socket->socket);
if (ret == 0) {
/* Add the yenta register attributes */
device_create_file(&dev->dev, &dev_attr_yenta_registers);
ret = device_create_file(&dev->dev, &dev_attr_yenta_registers);
if (ret == 0)
goto out;
/* error path... */
pcmcia_unregister_socket(&socket->socket);
}
unmap:
......@@ -1248,12 +1252,18 @@ static int yenta_dev_resume (struct pci_dev *dev)
struct yenta_socket *socket = pci_get_drvdata(dev);
if (socket) {
int rc;
pci_set_power_state(dev, 0);
/* FIXME: pci_restore_state needs to have a better interface */
pci_restore_state(dev);
pci_write_config_dword(dev, 16*4, socket->saved_state[0]);
pci_write_config_dword(dev, 17*4, socket->saved_state[1]);
pci_enable_device(dev);
rc = pci_enable_device(dev);
if (rc)
return rc;
pci_set_master(dev);
if (socket->type && socket->type->restore_state)
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册