firmware: ti_sci: Always request response from firmware

commit 66f030eac257a572fbedab3d9646d87d647351fd upstream.

TI-SCI firmware will only respond to messages when the
TI_SCI_FLAG_REQ_ACK_ON_PROCESSED flag is set. Most messages already do
this, set this for the ones that do not.

This will be enforced in future firmware that better match the TI-SCI
specifications, this patch will not break users of existing firmware.

Fixes: aa276781 ("firmware: Add basic support for TI System Control Interface (TI-SCI) protocol")
Signed-off-by: NAndrew F. Davis <afd@ti.com>
Acked-by: NNishanth Menon <nm@ti.com>
Tested-by: NAlejandro Hernandez <ajhernandez@ti.com>
Signed-off-by: NTero Kristo <t-kristo@ti.com>
Signed-off-by: NSantosh Shilimkar <santosh.shilimkar@oracle.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/firmware/ti_sci.c

@@ -463,9 +463,9 @@ static int ti_sci_cmd_get_revision(struct ti_sci_info *info)
 	struct ti_sci_xfer *xfer;
 	int ret;
 
-	/* No need to setup flags since it is expected to respond */
 	xfer = ti_sci_get_one_xfer(info, TI_SCI_MSG_VERSION,
-				   0x0, sizeof(struct ti_sci_msg_hdr),
+				   TI_SCI_FLAG_REQ_ACK_ON_PROCESSED,
+				   sizeof(struct ti_sci_msg_hdr),
 				   sizeof(*rev_info));
 	if (IS_ERR(xfer)) {
 		ret = PTR_ERR(xfer);
@@ -593,9 +593,9 @@ static int ti_sci_get_device_state(const struct ti_sci_handle *handle,
 	info = handle_to_ti_sci_info(handle);
 	dev = info->dev;
 
-	/* Response is expected, so need of any flags */
 	xfer = ti_sci_get_one_xfer(info, TI_SCI_MSG_GET_DEVICE_STATE,
-				   0, sizeof(*req), sizeof(*resp));
+				   TI_SCI_FLAG_REQ_ACK_ON_PROCESSED,
+				   sizeof(*req), sizeof(*resp));
 	if (IS_ERR(xfer)) {
 		ret = PTR_ERR(xfer);
 		dev_err(dev, "Message alloc failed(%d)\n", ret);