diff --git a/arch/i386/pci/fixup.c b/arch/i386/pci/fixup.c index c1949ff38d618c81dca67effe5e44c306c693b39..cde1170b01a1490e256ab2900cfef82f97787e0f 100644 --- a/arch/i386/pci/fixup.c +++ b/arch/i386/pci/fixup.c @@ -74,52 +74,6 @@ static void __devinit pci_fixup_ncr53c810(struct pci_dev *d) } DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_NCR, PCI_DEVICE_ID_NCR_53C810, pci_fixup_ncr53c810); -static void __devinit pci_fixup_ide_bases(struct pci_dev *d) -{ - int i; - - /* - * PCI IDE controllers use non-standard I/O port decoding, respect it. - */ - if ((d->class >> 8) != PCI_CLASS_STORAGE_IDE) - return; - DBG("PCI: IDE base address fixup for %s\n", pci_name(d)); - for(i=0; i<4; i++) { - struct resource *r = &d->resource[i]; - if ((r->start & ~0x80) == 0x374) { - r->start |= 2; - r->end = r->start; - } - } -} -DECLARE_PCI_FIXUP_HEADER(PCI_ANY_ID, PCI_ANY_ID, pci_fixup_ide_bases); - -static void __devinit pci_fixup_ide_trash(struct pci_dev *d) -{ - int i; - - /* - * Runs the fixup only for the first IDE controller - * (Shai Fultheim - shai@ftcon.com) - */ - static int called = 0; - if (called) - return; - called = 1; - - /* - * There exist PCI IDE controllers which have utter garbage - * in first four base registers. Ignore that. - */ - DBG("PCI: IDE base address trash cleared for %s\n", pci_name(d)); - for(i=0; i<4; i++) - d->resource[i].start = d->resource[i].end = d->resource[i].flags = 0; -} -DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_SI, PCI_DEVICE_ID_SI_5513, pci_fixup_ide_trash); -DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_10, pci_fixup_ide_trash); -DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_11, pci_fixup_ide_trash); -DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801DB_9, pci_fixup_ide_trash); - static void __devinit pci_fixup_latency(struct pci_dev *d) { /* diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c index e159d6604494acd62a617efcca0b6a3b26a8d4d4..0eeac60042b347052a0dc9d380d9d74de256735c 100644 --- a/drivers/pci/probe.c +++ b/drivers/pci/probe.c @@ -679,6 +679,33 @@ static int pci_setup_device(struct pci_dev * dev) pci_read_bases(dev, 6, PCI_ROM_ADDRESS); pci_read_config_word(dev, PCI_SUBSYSTEM_VENDOR_ID, &dev->subsystem_vendor); pci_read_config_word(dev, PCI_SUBSYSTEM_ID, &dev->subsystem_device); + + /* + * Do the ugly legacy mode stuff here rather than broken chip + * quirk code. Legacy mode ATA controllers have fixed + * addresses. These are not always echoed in BAR0-3, and + * BAR0-3 in a few cases contain junk! + */ + if (class == PCI_CLASS_STORAGE_IDE) { + u8 progif; + pci_read_config_byte(dev, PCI_CLASS_PROG, &progif); + if ((progif & 1) == 0) { + dev->resource[0].start = 0x1F0; + dev->resource[0].end = 0x1F7; + dev->resource[0].flags = IORESOURCE_IO; + dev->resource[1].start = 0x3F6; + dev->resource[1].end = 0x3F6; + dev->resource[1].flags = IORESOURCE_IO; + } + if ((progif & 4) == 0) { + dev->resource[2].start = 0x170; + dev->resource[2].end = 0x177; + dev->resource[2].flags = IORESOURCE_IO; + dev->resource[3].start = 0x376; + dev->resource[3].end = 0x376; + dev->resource[3].flags = IORESOURCE_IO; + } + } break; case PCI_HEADER_TYPE_BRIDGE: /* bridge header */ diff --git a/drivers/pci/quirks.c b/drivers/pci/quirks.c index 5b448381169193239d48ee89d6deab5827480d35..9ca9b9bf6160f337ee198d13a42775a7e3166b5a 100644 --- a/drivers/pci/quirks.c +++ b/drivers/pci/quirks.c @@ -796,56 +796,6 @@ static void __init quirk_mediagx_master(struct pci_dev *dev) } DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_CYRIX, PCI_DEVICE_ID_CYRIX_PCI_MASTER, quirk_mediagx_master ); -/* - * As per PCI spec, ignore base address registers 0-3 of the IDE controllers - * running in Compatible mode (bits 0 and 2 in the ProgIf for primary and - * secondary channels respectively). If the device reports Compatible mode - * but does use BAR0-3 for address decoding, we assume that firmware has - * programmed these BARs with standard values (0x1f0,0x3f4 and 0x170,0x374). - * Exceptions (if they exist) must be handled in chip/architecture specific - * fixups. - * - * Note: for non x86 people. You may need an arch specific quirk to handle - * moving IDE devices to native mode as well. Some plug in card devices power - * up in compatible mode and assume the BIOS will adjust them. - * - * Q: should we load the 0x1f0,0x3f4 into the registers or zap them as - * we do now ? We don't want is pci_enable_device to come along - * and assign new resources. Both approaches work for that. - */ -static void __devinit quirk_ide_bases(struct pci_dev *dev) -{ - struct resource *res; - int first_bar = 2, last_bar = 0; - - if ((dev->class >> 8) != PCI_CLASS_STORAGE_IDE) - return; - - res = &dev->resource[0]; - - /* primary channel: ProgIf bit 0, BAR0, BAR1 */ - if (!(dev->class & 1) && (res[0].flags || res[1].flags)) { - res[0].start = res[0].end = res[0].flags = 0; - res[1].start = res[1].end = res[1].flags = 0; - first_bar = 0; - last_bar = 1; - } - - /* secondary channel: ProgIf bit 2, BAR2, BAR3 */ - if (!(dev->class & 4) && (res[2].flags || res[3].flags)) { - res[2].start = res[2].end = res[2].flags = 0; - res[3].start = res[3].end = res[3].flags = 0; - last_bar = 3; - } - - if (!last_bar) - return; - - printk(KERN_INFO "PCI: Ignoring BAR%d-%d of IDE controller %s\n", - first_bar, last_bar, pci_name(dev)); -} -DECLARE_PCI_FIXUP_HEADER(PCI_ANY_ID, PCI_ANY_ID, quirk_ide_bases); - /* * Ensure C0 rev restreaming is off. This is normally done by * the BIOS but in the odd case it is not the results are corruption @@ -880,11 +830,10 @@ static void __devinit quirk_svwks_csb5ide(struct pci_dev *pdev) prog &= ~5; pdev->class &= ~5; pci_write_config_byte(pdev, PCI_CLASS_PROG, prog); - /* need to re-assign BARs for compat mode */ - quirk_ide_bases(pdev); + /* PCI layer will sort out resources */ } } -DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_SERVERWORKS, PCI_DEVICE_ID_SERVERWORKS_CSB5IDE, quirk_svwks_csb5ide ); +DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_SERVERWORKS, PCI_DEVICE_ID_SERVERWORKS_CSB5IDE, quirk_svwks_csb5ide ); /* * Intel 82801CAM ICH3-M datasheet says IDE modes must be the same @@ -900,11 +849,9 @@ static void __init quirk_ide_samemode(struct pci_dev *pdev) prog &= ~5; pdev->class &= ~5; pci_write_config_byte(pdev, PCI_CLASS_PROG, prog); - /* need to re-assign BARs for compat mode */ - quirk_ide_bases(pdev); } } -DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_10, quirk_ide_samemode); +DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_10, quirk_ide_samemode); /* This was originally an Alpha specific thing, but it really fits here. * The i82375 PCI/EISA bridge appears as non-classified. Fix that.