提交 2707df97 编写于 作者: V Vinicius Costa Gomes 提交者: Jeff Kirsher

igb: Fix the transmission mode of queue 0 for Qav mode

When Qav mode is enabled, queue 0 should be kept on Stream Reservation
mode. From the i210 datasheet, section 8.12.19:

"Note: Queue0 QueueMode must be set to 1b when TransmitMode is set to
Qav." ("QueueMode 1b" represents the Stream Reservation mode)

The solution is to give queue 0 the all the credits it might need, so
it has priority over queue 1.

A situation where this can happen is when cbs is "installed" only on
queue 1, leaving queue 0 alone. For example:

$ tc qdisc replace dev enp2s0 handle 100: parent root mqprio num_tc 3 \
     	   map 2 2 1 0 2 2 2 2 2 2 2 2 2 2 2 2 queues 1@0 1@1 2@2 hw 0

$ tc qdisc replace dev enp2s0 parent 100:2 cbs locredit -1470 \
     	   hicredit 30 sendslope -980000 idleslope 20000 offload 1
Signed-off-by: NVinicius Costa Gomes <vinicius.gomes@intel.com>
Tested-by: NAaron Brown <aaron.f.brown@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
上级 39035bfd
......@@ -1700,7 +1700,22 @@ static void igb_configure_cbs(struct igb_adapter *adapter, int queue,
WARN_ON(hw->mac.type != e1000_i210);
WARN_ON(queue < 0 || queue > 1);
if (enable) {
if (enable || queue == 0) {
/* i210 does not allow the queue 0 to be in the Strict
* Priority mode while the Qav mode is enabled, so,
* instead of disabling strict priority mode, we give
* queue 0 the maximum of credits possible.
*
* See section 8.12.19 of the i210 datasheet, "Note:
* Queue0 QueueMode must be set to 1b when
* TransmitMode is set to Qav."
*/
if (queue == 0 && !enable) {
/* max "linkspeed" idleslope in kbps */
idleslope = 1000000;
hicredit = ETH_FRAME_LEN;
}
set_tx_desc_fetch_prio(hw, queue, TX_QUEUE_PRIO_HIGH);
set_queue_mode(hw, queue, QUEUE_MODE_STREAM_RESERVATION);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册