brcmfmac: add hostap supoort.

This patch adds support for host AP mode.
Reviewed-by: NArend Van Spriel <arend@broadcom.com>
Reviewed-by: NFranky (Zhenhui) Lin <frankyl@broadcom.com>
Reviewed-by: NPieter-Paul Giesberts <pieterpg@broadcom.com>
Signed-off-by: NHante Meuleman <meuleman@broadcom.com>
Signed-off-by: NArend van Spriel <arend@broadcom.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

drivers/net/wireless/brcm80211/brcmfmac/dhd.h

@@ -27,6 +27,7 @@
  * IO codes that are interpreted by dongle firmware
  ******************************************************************************/
 #define BRCMF_C_UP				2
+#define BRCMF_C_DOWN				3
 #define BRCMF_C_SET_PROMISC			10
 #define BRCMF_C_GET_RATE			12
 #define BRCMF_C_GET_INFRA			19
@@ -50,7 +51,10 @@
 #define BRCMF_C_REASSOC				53
 #define BRCMF_C_SET_ROAM_TRIGGER		55
 #define BRCMF_C_SET_ROAM_DELTA			57
+#define BRCMF_C_GET_BCNPRD			75
+#define BRCMF_C_SET_BCNPRD			76
 #define BRCMF_C_GET_DTIMPRD			77
+#define BRCMF_C_SET_DTIMPRD			78
 #define BRCMF_C_SET_COUNTRY			84
 #define BRCMF_C_GET_PM				85
 #define BRCMF_C_SET_PM				86
@@ -134,6 +138,9 @@
 
 #define WLC_BSS_RSSI_ON_CHANNEL		0x0002
 
+#define BRCMF_MAXRATES_IN_SET		16	/* max # of rates in rateset */
+#define BRCMF_STA_ASSOC			0x10		/* Associated */
+
 struct brcmf_event_msg {
 	__be16 version;
 	__be16 flags;
@@ -566,6 +573,28 @@ struct brcmf_channel_info_le {
 	__le32 scan_channel;
 };
 
+struct brcmf_sta_info_le {
+	__le16	ver;		/* version of this struct */
+	__le16	len;		/* length in bytes of this structure */
+	__le16	cap;		/* sta's advertised capabilities */
+	__le32	flags;		/* flags defined below */
+	__le32	idle;		/* time since data pkt rx'd from sta */
+	u8	ea[ETH_ALEN];		/* Station address */
+	__le32	count;			/* # rates in this set */
+	u8	rates[BRCMF_MAXRATES_IN_SET];	/* rates in 500kbps units */
+						/* w/hi bit set if basic */
+	__le32	in;		/* seconds elapsed since associated */
+	__le32	listen_interval_inms; /* Min Listen interval in ms for STA */
+	__le32	tx_pkts;	/* # of packets transmitted */
+	__le32	tx_failures;	/* # of packets failed */
+	__le32	rx_ucast_pkts;	/* # of unicast packets received */
+	__le32	rx_mcast_pkts;	/* # of multicast packets received */
+	__le32	tx_rate;	/* Rate of last successful tx frame */
+	__le32	rx_rate;	/* Rate of last successful rx frame */
+	__le32	rx_decrypt_succeeds;	/* # of packet decrypted successfully */
+	__le32	rx_decrypt_failures;	/* # of packet decrypted failed */
+};
+
 /* Bus independent dongle command */
 struct brcmf_dcmd {
 	uint cmd;		/* common dongle cmd definition */

drivers/net/wireless/brcm80211/brcmfmac/wl_cfg80211.h

@@ -125,6 +125,7 @@ do {								\
 #define WL_ESCAN_ACTION_ABORT		3
 
 #define WL_AUTH_SHARED_KEY		1	/* d11 shared authentication */
+#define IE_MAX_LEN			512
 
 /* dongle status */
 enum wl_status {
@@ -132,7 +133,9 @@ enum wl_status {
 	WL_STATUS_SCANNING,
 	WL_STATUS_SCAN_ABORTING,
 	WL_STATUS_CONNECTING,
-	WL_STATUS_CONNECTED
+	WL_STATUS_CONNECTED,
+	WL_STATUS_AP_CREATING,
+	WL_STATUS_AP_CREATED
 };
 
 /* wi-fi mode */
@@ -285,6 +288,17 @@ struct escan_info {
 	struct net_device *ndev;
 };
 
+/* Structure to hold WPS, WPA IEs for a AP */
+struct ap_info {
+	u8 probe_res_ie[IE_MAX_LEN];
+	u8 beacon_ie[IE_MAX_LEN];
+	u32 probe_res_ie_len;
+	u32 beacon_ie_len;
+	u8 *wpa_ie;
+	u8 *rsn_ie;
+	bool security_mode;
+};
+
 /**
  * struct brcmf_pno_param_le - PNO scan configuration parameters
  *
@@ -407,6 +421,7 @@ struct brcmf_pno_scanresults_le {
  * @escan_timeout: Timer for catch scan timeout.
  * @escan_timeout_work: scan timeout worker.
  * @escan_ioctl_buf: dongle command buffer for escan commands.
+ * @ap_info: host ap information.
  * @ci: used to link this structure to netdev private data.
  */
 struct brcmf_cfg80211_priv {
@@ -448,6 +463,7 @@ struct brcmf_cfg80211_priv {
 	struct timer_list escan_timeout;
 	struct work_struct escan_timeout_work;
 	u8 *escan_ioctl_buf;
+	struct ap_info *ap_info;
 };
 
 static inline struct wiphy *cfg_to_wiphy(struct brcmf_cfg80211_priv *w)