diff --git a/arch/arm/boot/dts/dra72-evm.dts b/arch/arm/boot/dts/dra72-evm.dts
index 41074288adfa2003b07baa3d0b27f99255d0e0c4..6f5417a8b83f201dec82b5c132b5835f1a54c695 100644
--- a/arch/arm/boot/dts/dra72-evm.dts
+++ b/arch/arm/boot/dts/dra72-evm.dts
@@ -26,6 +26,33 @@
 			0x404 (PIN_INPUT | MUX_MODE0) /* i2c1_scl.i2c1_scl */
 		>;
 	};
+
+	nand_default: nand_default {
+		pinctrl-single,pins = <
+			0x0	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad0 */
+			0x4	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad1 */
+			0x8	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad2 */
+			0xc	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad3 */
+			0x10	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad4 */
+			0x14	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad5 */
+			0x18	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad6 */
+			0x1c	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad7 */
+			0x20	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad8 */
+			0x24	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad9 */
+			0x28	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad10 */
+			0x2c	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad11 */
+			0x30	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad12 */
+			0x34	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad13 */
+			0x38	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad14 */
+			0x3c	(PIN_INPUT  | MUX_MODE0) /* gpmc_ad15 */
+			0xb4	(PIN_OUTPUT | MUX_MODE0) /* gpmc_cs0 */
+			0xc4	(PIN_OUTPUT | MUX_MODE0) /* gpmc_advn_ale */
+			0xcc	(PIN_OUTPUT | MUX_MODE0) /* gpmc_wen */
+			0xc8	(PIN_OUTPUT | MUX_MODE0) /* gpmc_oen_ren */
+			0xd0	(PIN_OUTPUT | MUX_MODE0) /* gpmc_ben0 */
+			0xd8	(PIN_INPUT  | MUX_MODE0) /* gpmc_wait0 */
+		>;
+	};
 };
 
 &i2c1 {
@@ -142,3 +169,91 @@
 &uart1 {
 	status = "okay";
 };
+
+&elm {
+	status = "okay";
+};
+
+&gpmc {
+	status = "okay";
+	pinctrl-names = "default";
+	pinctrl-0 = <&nand_default>;
+	ranges = <0 0 0 0x01000000>;	/* minimum GPMC partition = 16MB */
+	nand@0,0 {
+		/* To use NAND, DIP switch SW5 must be set like so:
+		 * SW5.1 (NAND_SELn) = ON (LOW)
+		 * SW5.9 (GPMC_WPN) = OFF (HIGH)
+		 */
+		reg = <0 0 4>;		/* device IO registers */
+		ti,nand-ecc-opt = "bch8";
+		ti,elm-id = <&elm>;
+		nand-bus-width = <16>;
+		gpmc,device-width = <2>;
+		gpmc,sync-clk-ps = <0>;
+		gpmc,cs-on-ns = <0>;
+		gpmc,cs-rd-off-ns = <80>;
+		gpmc,cs-wr-off-ns = <80>;
+		gpmc,adv-on-ns = <0>;
+		gpmc,adv-rd-off-ns = <60>;
+		gpmc,adv-wr-off-ns = <60>;
+		gpmc,we-on-ns = <10>;
+		gpmc,we-off-ns = <50>;
+		gpmc,oe-on-ns = <4>;
+		gpmc,oe-off-ns = <40>;
+		gpmc,access-ns = <40>;
+		gpmc,wr-access-ns = <80>;
+		gpmc,rd-cycle-ns = <80>;
+		gpmc,wr-cycle-ns = <80>;
+		gpmc,bus-turnaround-ns = <0>;
+		gpmc,cycle2cycle-delay-ns = <0>;
+		gpmc,clk-activation-ns = <0>;
+		gpmc,wait-monitoring-ns = <0>;
+		gpmc,wr-data-mux-bus-ns = <0>;
+		/* MTD partition table */
+		/* All SPL-* partitions are sized to minimal length
+		 * which can be independently programmable. For
+		 * NAND flash this is equal to size of erase-block */
+		#address-cells = <1>;
+		#size-cells = <1>;
+		partition@0 {
+			label = "NAND.SPL";
+			reg = <0x00000000 0x000020000>;
+		};
+		partition@1 {
+			label = "NAND.SPL.backup1";
+			reg = <0x00020000 0x00020000>;
+		};
+		partition@2 {
+			label = "NAND.SPL.backup2";
+			reg = <0x00040000 0x00020000>;
+		};
+		partition@3 {
+			label = "NAND.SPL.backup3";
+			reg = <0x00060000 0x00020000>;
+		};
+		partition@4 {
+			label = "NAND.u-boot-spl-os";
+			reg = <0x00080000 0x00040000>;
+		};
+		partition@5 {
+			label = "NAND.u-boot";
+			reg = <0x000c0000 0x00100000>;
+		};
+		partition@6 {
+			label = "NAND.u-boot-env";
+			reg = <0x001c0000 0x00020000>;
+		};
+		partition@7 {
+			label = "NAND.u-boot-env.backup1";
+			reg = <0x001e0000 0x00020000>;
+		};
+		partition@8 {
+			label = "NAND.kernel";
+			reg = <0x00200000 0x00800000>;
+		};
+		partition@9 {
+			label = "NAND.file-system";
+			reg = <0x00a00000 0x0f600000>;
+		};
+	};
+};