提交 08a7b29b 编写于 作者: B Bert Kenward 提交者: David S. Miller

sfc: support ndo_get_phys_port_id even when !CONFIG_SFC_SRIOV

There's no good reason why this should be an SRIOV-only thing.
Thus, also move it out of SRIOV-specific files.
Signed-off-by: NEdward Cree <ecree@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 79f664ed
......@@ -5540,6 +5540,20 @@ static int efx_ef10_ptp_set_ts_config(struct efx_nic *efx,
}
}
static int efx_ef10_get_phys_port_id(struct efx_nic *efx,
struct netdev_phys_item_id *ppid)
{
struct efx_ef10_nic_data *nic_data = efx->nic_data;
if (!is_valid_ether_addr(nic_data->port_id))
return -EOPNOTSUPP;
ppid->id_len = ETH_ALEN;
memcpy(ppid->id, nic_data->port_id, ppid->id_len);
return 0;
}
static int efx_ef10_vlan_rx_add_vid(struct efx_nic *efx, __be16 proto, u16 vid)
{
if (proto != htons(ETH_P_8021Q))
......@@ -5647,11 +5661,11 @@ const struct efx_nic_type efx_hunt_a0_vf_nic_type = {
.vswitching_probe = efx_ef10_vswitching_probe_vf,
.vswitching_restore = efx_ef10_vswitching_restore_vf,
.vswitching_remove = efx_ef10_vswitching_remove_vf,
.sriov_get_phys_port_id = efx_ef10_sriov_get_phys_port_id,
#endif
.get_mac_address = efx_ef10_get_mac_address_vf,
.set_mac_address = efx_ef10_set_mac_address,
.get_phys_port_id = efx_ef10_get_phys_port_id,
.revision = EFX_REV_HUNT_A0,
.max_dma_mask = DMA_BIT_MASK(ESF_DZ_TX_KER_BUF_ADDR_WIDTH),
.rx_prefix_size = ES_DZ_RX_PREFIX_SIZE,
......@@ -5776,6 +5790,7 @@ const struct efx_nic_type efx_hunt_a0_nic_type = {
.set_mac_address = efx_ef10_set_mac_address,
.tso_versions = efx_ef10_tso_versions,
.get_phys_port_id = efx_ef10_get_phys_port_id,
.revision = EFX_REV_HUNT_A0,
.max_dma_mask = DMA_BIT_MASK(ESF_DZ_TX_KER_BUF_ADDR_WIDTH),
.rx_prefix_size = ES_DZ_RX_PREFIX_SIZE,
......
......@@ -760,17 +760,3 @@ int efx_ef10_sriov_get_vf_config(struct efx_nic *efx, int vf_i,
return 0;
}
int efx_ef10_sriov_get_phys_port_id(struct efx_nic *efx,
struct netdev_phys_item_id *ppid)
{
struct efx_ef10_nic_data *nic_data = efx->nic_data;
if (!is_valid_ether_addr(nic_data->port_id))
return -EOPNOTSUPP;
ppid->id_len = ETH_ALEN;
memcpy(ppid->id, nic_data->port_id, ppid->id_len);
return 0;
}
......@@ -56,9 +56,6 @@ int efx_ef10_sriov_get_vf_config(struct efx_nic *efx, int vf_i,
int efx_ef10_sriov_set_vf_link_state(struct efx_nic *efx, int vf_i,
int link_state);
int efx_ef10_sriov_get_phys_port_id(struct efx_nic *efx,
struct netdev_phys_item_id *ppid);
int efx_ef10_vswitching_probe_pf(struct efx_nic *efx);
int efx_ef10_vswitching_probe_vf(struct efx_nic *efx);
int efx_ef10_vswitching_restore_pf(struct efx_nic *efx);
......
......@@ -2334,6 +2334,17 @@ static int efx_set_features(struct net_device *net_dev, netdev_features_t data)
return 0;
}
int efx_get_phys_port_id(struct net_device *net_dev,
struct netdev_phys_item_id *ppid)
{
struct efx_nic *efx = netdev_priv(net_dev);
if (efx->type->get_phys_port_id)
return efx->type->get_phys_port_id(efx, ppid);
else
return -EOPNOTSUPP;
}
static int efx_vlan_rx_add_vid(struct net_device *net_dev, __be16 proto, u16 vid)
{
struct efx_nic *efx = netdev_priv(net_dev);
......@@ -2374,8 +2385,8 @@ static const struct net_device_ops efx_netdev_ops = {
.ndo_set_vf_spoofchk = efx_sriov_set_vf_spoofchk,
.ndo_get_vf_config = efx_sriov_get_vf_config,
.ndo_set_vf_link_state = efx_sriov_set_vf_link_state,
.ndo_get_phys_port_id = efx_sriov_get_phys_port_id,
#endif
.ndo_get_phys_port_id = efx_get_phys_port_id,
#ifdef CONFIG_NET_POLL_CONTROLLER
.ndo_poll_controller = efx_netpoll,
#endif
......
......@@ -1220,6 +1220,7 @@ struct efx_mtd_partition {
* @ptp_set_ts_config: Set hardware timestamp configuration. The flags
* and tx_type will already have been validated but this operation
* must validate and update rx_filter.
* @get_phys_port_id: Get the underlying physical port id.
* @set_mac_address: Set the MAC address of the device
* @tso_versions: Returns mask of firmware-assisted TSO versions supported.
* If %NULL, then device does not support any TSO version.
......@@ -1358,6 +1359,8 @@ struct efx_nic_type {
int (*sriov_configure)(struct efx_nic *efx, int num_vfs);
int (*vlan_rx_add_vid)(struct efx_nic *efx, __be16 proto, u16 vid);
int (*vlan_rx_kill_vid)(struct efx_nic *efx, __be16 proto, u16 vid);
int (*get_phys_port_id)(struct efx_nic *efx,
struct netdev_phys_item_id *ppid);
int (*sriov_init)(struct efx_nic *efx);
void (*sriov_fini)(struct efx_nic *efx);
bool (*sriov_wanted)(struct efx_nic *efx);
......@@ -1372,8 +1375,6 @@ struct efx_nic_type {
struct ifla_vf_info *ivi);
int (*sriov_set_vf_link_state)(struct efx_nic *efx, int vf_i,
int link_state);
int (*sriov_get_phys_port_id)(struct efx_nic *efx,
struct netdev_phys_item_id *ppid);
int (*vswitching_probe)(struct efx_nic *efx);
int (*vswitching_restore)(struct efx_nic *efx);
void (*vswitching_remove)(struct efx_nic *efx);
......
......@@ -73,14 +73,3 @@ int efx_sriov_set_vf_link_state(struct net_device *net_dev, int vf_i,
else
return -EOPNOTSUPP;
}
int efx_sriov_get_phys_port_id(struct net_device *net_dev,
struct netdev_phys_item_id *ppid)
{
struct efx_nic *efx = netdev_priv(net_dev);
if (efx->type->sriov_get_phys_port_id)
return efx->type->sriov_get_phys_port_id(efx, ppid);
else
return -EOPNOTSUPP;
}
......@@ -23,9 +23,6 @@ int efx_sriov_get_vf_config(struct net_device *net_dev, int vf_i,
struct ifla_vf_info *ivi);
int efx_sriov_set_vf_link_state(struct net_device *net_dev, int vf_i,
int link_state);
int efx_sriov_get_phys_port_id(struct net_device *net_dev,
struct netdev_phys_item_id *ppid);
#endif /* CONFIG_SFC_SRIOV */
#endif /* EFX_SRIOV_H */
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册