提交 176efb05 编写于 作者: M Mikael Pettersson 提交者: Jeff Garzik

sata_promise: decode and report error reasons

This patch adds much needed error reason decoding and
reporting to sata_promise. It's simplistic but should
log all relevant error info the controller provides.
Signed-off-by: NMikael Pettersson <mikpe@it.uu.se>
Signed-off-by: NJeff Garzik <jeff@garzik.org>
上级 724114a5
......@@ -45,7 +45,7 @@
#include "sata_promise.h"
#define DRV_NAME "sata_promise"
#define DRV_VERSION "2.03"
#define DRV_VERSION "2.04"
enum {
......@@ -70,8 +70,23 @@ enum {
PDC_TBG_MODE = 0x41C, /* TBG mode (not SATAII) */
PDC_SLEW_CTL = 0x470, /* slew rate control reg (not SATAII) */
PDC_ERR_MASK = (1<<19) | (1<<20) | (1<<21) | (1<<22) |
(1<<8) | (1<<9) | (1<<10),
/* PDC_GLOBAL_CTL bit definitions */
PDC_PH_ERR = (1 << 8), /* PCI error while loading packet */
PDC_SH_ERR = (1 << 9), /* PCI error while loading S/G table */
PDC_DH_ERR = (1 << 10), /* PCI error while loading data */
PDC2_HTO_ERR = (1 << 12), /* host bus timeout */
PDC2_ATA_HBA_ERR = (1 << 13), /* error during SATA DATA FIS transmission */
PDC2_ATA_DMA_CNT_ERR = (1 << 14), /* DMA DATA FIS size differs from S/G count */
PDC_OVERRUN_ERR = (1 << 19), /* S/G byte count larger than HD requires */
PDC_UNDERRUN_ERR = (1 << 20), /* S/G byte count less than HD requires */
PDC_DRIVE_ERR = (1 << 21), /* drive error */
PDC_PCI_SYS_ERR = (1 << 22), /* PCI system error */
PDC1_PCI_PARITY_ERR = (1 << 23), /* PCI parity error (from SATA150 driver) */
PDC1_ERR_MASK = PDC1_PCI_PARITY_ERR,
PDC2_ERR_MASK = PDC2_HTO_ERR | PDC2_ATA_HBA_ERR | PDC2_ATA_DMA_CNT_ERR,
PDC_ERR_MASK = (PDC_PH_ERR | PDC_SH_ERR | PDC_DH_ERR | PDC_OVERRUN_ERR
| PDC_UNDERRUN_ERR | PDC_DRIVE_ERR | PDC_PCI_SYS_ERR
| PDC1_ERR_MASK | PDC2_ERR_MASK),
board_2037x = 0, /* FastTrak S150 TX2plus */
board_20319 = 1, /* FastTrak S150 TX4 */
......@@ -615,17 +630,48 @@ static void pdc_post_internal_cmd(struct ata_queued_cmd *qc)
pdc_reset_port(ap);
}
static void pdc_error_intr(struct ata_port *ap, struct ata_queued_cmd *qc,
u32 port_status, u32 err_mask)
{
struct ata_eh_info *ehi = &ap->eh_info;
unsigned int ac_err_mask = 0;
ata_ehi_clear_desc(ehi);
ata_ehi_push_desc(ehi, "port_status 0x%08x", port_status);
port_status &= err_mask;
if (port_status & PDC_DRIVE_ERR)
ac_err_mask |= AC_ERR_DEV;
if (port_status & (PDC_OVERRUN_ERR | PDC_UNDERRUN_ERR))
ac_err_mask |= AC_ERR_HSM;
if (port_status & (PDC2_ATA_HBA_ERR | PDC2_ATA_DMA_CNT_ERR))
ac_err_mask |= AC_ERR_ATA_BUS;
if (port_status & (PDC_PH_ERR | PDC_SH_ERR | PDC_DH_ERR | PDC2_HTO_ERR
| PDC_PCI_SYS_ERR | PDC1_PCI_PARITY_ERR))
ac_err_mask |= AC_ERR_HOST_BUS;
ehi->action |= ATA_EH_SOFTRESET;
qc->err_mask |= ac_err_mask;
ata_port_freeze(ap);
}
static inline unsigned int pdc_host_intr( struct ata_port *ap,
struct ata_queued_cmd *qc)
{
unsigned int handled = 0;
u32 tmp;
void __iomem *mmio = ap->ioaddr.cmd_addr + PDC_GLOBAL_CTL;
void __iomem *port_mmio = ap->ioaddr.cmd_addr;
struct pdc_host_priv *hp = ap->host->private_data;
u32 port_status, err_mask;
tmp = readl(mmio);
if (tmp & PDC_ERR_MASK) {
qc->err_mask |= AC_ERR_DEV;
pdc_reset_port(ap);
err_mask = PDC_ERR_MASK;
if (hp->flags & PDC_FLAG_GEN_II)
err_mask &= ~PDC1_ERR_MASK;
else
err_mask &= ~PDC2_ERR_MASK;
port_status = readl(port_mmio + PDC_GLOBAL_CTL);
if (unlikely(port_status & err_mask)) {
pdc_error_intr(ap, qc, port_status, err_mask);
return 1;
}
switch (qc->tf.protocol) {
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册