powerpc/wsp: Permanently enable PCI class code workaround

It appears that on the Chroma card, the class code of the root
complex is still wrong even on DD2 or later chips. This could
be a firmware issue, but that breaks resource allocation so let's
unconditionally fix it up.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>

arch/powerpc/platforms/wsp/wsp_pci.c

@@ -468,15 +468,15 @@ static void __init wsp_pcie_configure_hw(struct pci_controller *hose)
 #define DUMP_REG(x) \
 	pr_debug("%-30s : 0x%016llx\n", #x, in_be64(hose->cfg_data + x))
 
-#ifdef CONFIG_WSP_DD1_WORKAROUND_BAD_PCIE_CLASS
-	/* WSP DD1 has a bogus class code by default in the PCI-E
-	 * root complex's built-in P2P bridge */
+	/*
+	 * Some WSP variants  has a bogus class code by default in the PCI-E
+	 * root complex's built-in P2P bridge
+	 */
 	val = in_be64(hose->cfg_data + PCIE_REG_SYS_CFG1);
 	pr_debug("PCI-E SYS_CFG1 : 0x%llx\n", val);
 	out_be64(hose->cfg_data + PCIE_REG_SYS_CFG1,
 		 (val & ~PCIE_REG_SYS_CFG1_CLASS_CODE) | (PCI_CLASS_BRIDGE_PCI << 8));
 	pr_debug("PCI-E SYS_CFG1 : 0x%llx\n", in_be64(hose->cfg_data + PCIE_REG_SYS_CFG1));
-#endif /* CONFIG_WSP_DD1_WORKAROUND_BAD_PCIE_CLASS */
 
 #ifdef CONFIG_WSP_DD1_WORKAROUND_DD1_TCE_BUGS
 	/* XXX Disable TCE caching, it doesn't work on DD1 */