提交 980d0d51 编写于 作者: L Linus Torvalds

Merge tag 'pinctrl-v3.18-2' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl

Pull pin-control fixes from Linus Walleij:
 "This kernel cycle has been calm for both pin control and GPIO so far
  but here are three pin control patches for you anyway, only really
  dealing with Baytrail:

   - Two fixes for the Baytrail driver affecting IRQs and output state
     in sysfs
   - Use the linux-gpio mailing list also for pinctrl patches"

* tag 'pinctrl-v3.18-2' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl:
  pinctrl: baytrail: show output gpio state correctly on Intel Baytrail
  pinctrl: use linux-gpio mailing list
  pinctrl: baytrail: Clear DIRECT_IRQ bit
......@@ -7180,6 +7180,7 @@ F: drivers/crypto/picoxcell*
PIN CONTROL SUBSYSTEM
M: Linus Walleij <linus.walleij@linaro.org>
L: linux-gpio@vger.kernel.org
S: Maintained
F: drivers/pinctrl/
F: include/linux/pinctrl/
......
......@@ -227,10 +227,14 @@ static int byt_irq_type(struct irq_data *d, unsigned type)
spin_lock_irqsave(&vg->lock, flags);
value = readl(reg);
WARN(value & BYT_DIRECT_IRQ_EN,
"Bad pad config for io mode, force direct_irq_en bit clearing");
/* For level trigges the BYT_TRIG_POS and BYT_TRIG_NEG bits
* are used to indicate high and low level triggering
*/
value &= ~(BYT_TRIG_POS | BYT_TRIG_NEG | BYT_TRIG_LVL);
value &= ~(BYT_DIRECT_IRQ_EN | BYT_TRIG_POS | BYT_TRIG_NEG |
BYT_TRIG_LVL);
switch (type) {
case IRQ_TYPE_LEVEL_HIGH:
......@@ -318,7 +322,7 @@ static int byt_gpio_direction_output(struct gpio_chip *chip,
"Potential Error: Setting GPIO with direct_irq_en to output");
reg_val = readl(reg) | BYT_DIR_MASK;
reg_val &= ~BYT_OUTPUT_EN;
reg_val &= ~(BYT_OUTPUT_EN | BYT_INPUT_EN);
if (value)
writel(reg_val | BYT_LEVEL, reg);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册