提交 346eef2f 编写于 作者: L Linus Torvalds

Merge tag 'spi-v3.19-rc2' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi

Pull spi fixes from Mark Brown:
 "A few driver specific fixes here, the DMA burst size increase in the
  spfi driver is a fix to make the hardware happier in some situations"

* tag 'spi-v3.19-rc2' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi:
  spi: img-spfi: Increase DMA burst size
  spi: img-spfi: Enable controller before starting TX DMA
  spi: sh-msiof: Add runtime PM lock in initializing
......@@ -341,7 +341,7 @@ static int img_spfi_start_dma(struct spi_master *master,
default:
rxconf.src_addr = spfi->phys + SPFI_RX_8BIT_VALID_DATA;
rxconf.src_addr_width = 1;
rxconf.src_maxburst = 1;
rxconf.src_maxburst = 4;
}
dmaengine_slave_config(spfi->rx_ch, &rxconf);
......@@ -368,7 +368,7 @@ static int img_spfi_start_dma(struct spi_master *master,
default:
txconf.dst_addr = spfi->phys + SPFI_TX_8BIT_VALID_DATA;
txconf.dst_addr_width = 1;
txconf.dst_maxburst = 1;
txconf.dst_maxburst = 4;
break;
}
dmaengine_slave_config(spfi->tx_ch, &txconf);
......@@ -390,14 +390,14 @@ static int img_spfi_start_dma(struct spi_master *master,
dma_async_issue_pending(spfi->rx_ch);
}
spfi_start(spfi);
if (xfer->tx_buf) {
spfi->tx_dma_busy = true;
dmaengine_submit(txdesc);
dma_async_issue_pending(spfi->tx_ch);
}
spfi_start(spfi);
return 1;
stop_dma:
......
......@@ -480,6 +480,8 @@ static int sh_msiof_spi_setup(struct spi_device *spi)
struct device_node *np = spi->master->dev.of_node;
struct sh_msiof_spi_priv *p = spi_master_get_devdata(spi->master);
pm_runtime_get_sync(&p->pdev->dev);
if (!np) {
/*
* Use spi->controller_data for CS (same strategy as spi_gpio),
......@@ -498,6 +500,9 @@ static int sh_msiof_spi_setup(struct spi_device *spi)
if (spi->cs_gpio >= 0)
gpio_set_value(spi->cs_gpio, !(spi->mode & SPI_CS_HIGH));
pm_runtime_put_sync(&p->pdev->dev);
return 0;
}
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册