提交 3161293b 编写于 作者: G Gabriele Mazzotta 提交者: Darren Hart

Documentation: Add entry for dell-laptop sysfs interface

Add the documentation for the new sysfs interface of dell-laptop
that allows to configure the keyboard illumination on Dell systems.
Signed-off-by: NGabriele Mazzotta <gabriele.mzt@gmail.com>
Signed-off-by: NPali Rohár <pali.rohar@gmail.com>
Signed-off-by: NDarren Hart <dvhart@linux.intel.com>
上级 cc888de2
What: /sys/class/leds/dell::kbd_backlight/als_setting
Date: December 2014
KernelVersion: 3.19
Contact: Gabriele Mazzotta <gabriele.mzt@gmail.com>,
Pali Rohár <pali.rohar@gmail.com>
Description:
This file allows to control the automatic keyboard
illumination mode on some systems that have an ambient
light sensor. Write 1 to this file to enable the auto
mode, 0 to disable it.
What: /sys/class/leds/dell::kbd_backlight/start_triggers
Date: December 2014
KernelVersion: 3.19
Contact: Gabriele Mazzotta <gabriele.mzt@gmail.com>,
Pali Rohár <pali.rohar@gmail.com>
Description:
This file allows to control the input triggers that
turn on the keyboard backlight illumination that is
disabled because of inactivity.
Read the file to see the triggers available. The ones
enabled are preceded by '+', those disabled by '-'.
To enable a trigger, write its name preceded by '+' to
this file. To disable a trigger, write its name preceded
by '-' instead.
For example, to enable the keyboard as trigger run:
echo +keyboard > /sys/class/leds/dell::kbd_backlight/start_triggers
To disable it:
echo -keyboard > /sys/class/leds/dell::kbd_backlight/start_triggers
Note that not all the available triggers can be configured.
What: /sys/class/leds/dell::kbd_backlight/stop_timeout
Date: December 2014
KernelVersion: 3.19
Contact: Gabriele Mazzotta <gabriele.mzt@gmail.com>,
Pali Rohár <pali.rohar@gmail.com>
Description:
This file allows to specify the interval after which the
keyboard illumination is disabled because of inactivity.
The timeouts are expressed in seconds, minutes, hours and
days, for which the symbols are 's', 'm', 'h' and 'd'
respectively.
To configure the timeout, write to this file a value along
with any the above units. If no unit is specified, the value
is assumed to be expressed in seconds.
For example, to set the timeout to 10 minutes run:
echo 10m > /sys/class/leds/dell::kbd_backlight/stop_timeout
Note that when this file is read, the returned value might be
expressed in a different unit than the one used when the timeout
was set.
Also note that only some timeouts are supported and that
some systems might fall back to a specific timeout in case
an invalid timeout is written to this file.
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册