- 01 3月, 2008 1 次提交
-
-
由 Kim B. Heino 提交于
Current tun/tap driver sets also net device's hw address when asked to change character device's hw address. This is a good idea, but it misses RTLN-locking, resulting following error message in 2.6.25-rc3's inetdev_event() function: RTNL: assertion failed at net/ipv4/devinet.c (1050) Attached patch fixes this problem. Signed-off-by: NKim B. Heino <Kim.Heino@bluegiga.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 05 2月, 2008 1 次提交
-
-
由 Nathaniel Filardo 提交于
From: "Nathaniel Filardo" <nwfilardo@gmail.com> Taken from http://bugzilla.kernel.org/show_bug.cgi?id=9806 The TUN/TAP driver only permits one-way transitions of IFF_NO_PI or IFF_ONE_QUEUE during the lifetime of a tap/tun interface. Note that tun_set_iff contains 541 if (ifr->ifr_flags & IFF_NO_PI) 542 tun->flags |= TUN_NO_PI; 543 544 if (ifr->ifr_flags & IFF_ONE_QUEUE) 545 tun->flags |= TUN_ONE_QUEUE; This is easily fixed by adding else branches which clear these bits. Steps to reproduce: This is easily reproduced by setting an interface persistant using tunctl then attempting to open it as IFF_TAP or IFF_TUN, without asserting the IFF_NO_PI flag. The ioctl() will succeed and the ifr.flags word is not modified, but the interface remains in IFF_NO_PI mode (as it was set by tunctl). Acked-by: NMaxim Krasnyansky <maxk@qualcomm.com> Signed-off-by: NAndrew Morton <akpm@linux-foundation.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 29 1月, 2008 2 次提交
-
-
由 Al Viro 提交于
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk> Signed-off-by: NJeff Garzik <jeff@garzik.org>
-
由 Akinobu Mita 提交于
Use iov_length() instead of tun's homemade iov_total(). Signed-off-by: NAkinobu Mita <akinobu.mita@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 27 12月, 2007 1 次提交
-
-
由 Toyo Abe 提交于
This is a trivial fix of debug message. When a persist flag is set, the message should say "enabled". Signed-off-by: NToyo Abe <tabe@miraclelinux.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 11 10月, 2007 5 次提交
-
-
由 Joe Perches 提交于
This is nicer than the MAC_FMT stuff. Signed-off-by: NJoe Perches <joe@perches.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Ed Swierk 提交于
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Jeff Garzik 提交于
We now have struct net_device_stats embedded in struct net_device, and the default ->get_stats() hook does the obvious thing for us. Run through drivers/net/* and remove the driver-local storage of statistics, and driver-local ->get_stats() hook where applicable. This was just the low-hanging fruit in drivers/net; plenty more drivers remain to be updated. [ Resolved conflicts with napi_struct changes and fix sunqe build regression... -DaveM ] Signed-off-by: NJeff Garzik <jeff@garzik.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Ralf Baechle 提交于
It's been a useless no-op for long enough in 2.6 so I figured it's time to remove it. The number of people that could object because they're maintaining unified 2.4 and 2.6 drivers is probably rather small. [ Handled drivers added by netdev tree and some missed IRDA cases... -DaveM ] Signed-off-by: NRalf Baechle <ralf@linux-mips.org> Signed-off-by: NJeff Garzik <jeff@garzik.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Eric W. Biederman 提交于
This patch makes most of the generic device layer network namespace safe. This patch makes dev_base_head a network namespace variable, and then it picks up a few associated variables. The functions: dev_getbyhwaddr dev_getfirsthwbytype dev_get_by_flags dev_get_by_name __dev_get_by_name dev_get_by_index __dev_get_by_index dev_ioctl dev_ethtool dev_load wireless_process_ioctl were modified to take a network namespace argument, and deal with it. vlan_ioctl_set and brioctl_set were modified so their hooks will receive a network namespace argument. So basically anthing in the core of the network stack that was affected to by the change of dev_base was modified to handle multiple network namespaces. The rest of the network stack was simply modified to explicitly use &init_net the initial network namespace. This can be fixed when those components of the network stack are modified to handle multiple network namespaces. For now the ifindex generator is left global. Fundametally ifindex numbers are per namespace, or else we will have corner case problems with migration when we get that far. At the same time there are assumptions in the network stack that the ifindex of a network device won't change. Making the ifindex number global seems a good compromise until the network stack can cope with ifindex changes when you change namespaces, and the like. Signed-off-by: NEric W. Biederman <ebiederm@xmission.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 11 7月, 2007 1 次提交
-
-
由 Guido Guenther 提交于
Introduce a new syscall TUNSETGROUP for group ownership setting of tap devices. The user now is allowed to send packages if either his euid or his egid matches the one specified via tunctl (via -u or -g respecitvely). If both, gid and uid, are set via tunctl, both have to match. Signed-off-by: NGuido Guenther <agx@sigxcpu.org> Signed-off-by: NJeff Dike <jdike@linux.intel.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 26 4月, 2007 4 次提交
-
-
由 Brian Braunstein 提交于
Fixed tun/tap driver's handling of hw addresses. The hw address is stored in both the net_device.dev_addr and tun.dev_addr fields. These fields were not kept synchronized, and in fact weren't even initialized to the same value. Now during both init and when performing SIOCSIFHWADDR on the tun device these values are both updated. However, if SIOCSIFHWADDR is performed on the net device directly (for instance, setting the hw address using ifconfig), the tun device does not get updated. Perhaps the tun.dev_addr field should be removed completely at some point, as it is redundant and net_device.dev_addr can be used anywhere it is used. Signed-off-by: NBrian Braunstein <linuxkernel@bristyle.com> Signed-off-by: NAndrew Morton <akpm@linux-foundation.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Arnaldo Carvalho de Melo 提交于
To clearly state the intent of copying from linear sk_buffs, _offset being a overly long variant but interesting for the sake of saving some bytes. Signed-off-by: NArnaldo Carvalho de Melo <acme@redhat.com>
-
由 Arnaldo Carvalho de Melo 提交于
For the common, open coded 'skb->mac.raw = skb->data' operation, so that we can later turn skb->mac.raw into a offset, reducing the size of struct sk_buff in 64bit land while possibly keeping it as a pointer on 32bit. This one touches just the most simple case, next will handle the slightly more "complex" cases. Signed-off-by: NArnaldo Carvalho de Melo <acme@redhat.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Arnaldo Carvalho de Melo 提交于
One less thing for drivers writers to worry about. Signed-off-by: NArnaldo Carvalho de Melo <acme@redhat.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 13 2月, 2007 1 次提交
-
-
由 Arjan van de Ven 提交于
Many struct file_operations in the kernel can be "const". Marking them const moves these to the .rodata section, which avoids false sharing with potential dirty data. In addition it'll catch accidental writes at compile time to these shared resources. Signed-off-by: NArjan van de Ven <arjan@linux.intel.com> Signed-off-by: NAndrew Morton <akpm@linux-foundation.org> Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
-
- 02 10月, 2006 1 次提交
-
-
由 Eric W. Biederman 提交于
File handles can be requested to send sigio and sigurg to processes. By tracking the destination processes using struct pid instead of pid_t we make the interface safe from all potential pid wrap around problems. Signed-off-by: NEric W. Biederman <ebiederm@xmission.com> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 01 10月, 2006 1 次提交
-
-
由 Badari Pulavarty 提交于
This patch removes readv() and writev() methods and replaces them with aio_read()/aio_write() methods. Signed-off-by: NBadari Pulavarty <pbadari@us.ibm.com> Signed-off-by: NChristoph Hellwig <hch@lst.de> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 14 9月, 2006 2 次提交
-
-
由 Jeff Garzik 提交于
Signed-off-by: NJeff Garzik <jeff@garzik.org>
-
由 Jeff Garzik 提交于
Signed-off-by: NJeff Garzik <jeff@garzik.org>
-
- 01 7月, 2006 1 次提交
-
-
由 Jörn Engel 提交于
Signed-off-by: NJörn Engel <joern@wohnheim.fh-wedel.de> Signed-off-by: NAdrian Bunk <bunk@stusta.de>
-
- 27 6月, 2006 1 次提交
-
-
由 Greg Kroah-Hartman 提交于
Also fixes all drivers that set this field. Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
-
- 23 6月, 2006 1 次提交
-
-
由 David Woodhouse 提交于
The tuntap driver allows an admin to create persistent devices and assign ownership of them to individual users. Unfortunately, relaxing the permissions on the /dev/net/tun device node so that they can actually use those devices will _also_ allow those users to create arbitrary new devices of their own. This patch corrects that, and adjusts the recommended permissions for the device node accordingly. Signed-off-By: NDavid Woodhouse <dwmw2@infradead.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 12 3月, 2006 1 次提交
-
-
由 Dave Jones 提交于
We're leaking an skb in a failure path in this function. Coverity #632 Signed-off-by: NDave Jones <davej@redhat.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 02 9月, 2005 1 次提交
-
-
由 Mike Kershaw 提交于
Currently tun/tap only supports the EN10MB ARP type. For use with wireless and other networking types it should be possible to set the ARP type via an ioctl. Patch v2: Included check that the tap interface is down before changing the link type out from underneath it Signed-off-by: NMike Kershaw <dragorn@kismetwireless.net> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 09 7月, 2005 1 次提交
-
-
由 David S. Miller 提交于
This is part of the grand scheme to eliminate the qlen member of skb_queue_head, and subsequently remove the 'list' member of sk_buff. Most users of skb_queue_len() want to know if the queue is empty or not, and that's trivially done with skb_queue_empty() which doesn't use the skb_queue_head->qlen member and instead uses the queue list emptyness as the test. Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 17 4月, 2005 1 次提交
-
-
由 Linus Torvalds 提交于
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
-